Product overview
- Part Number
- GM8112-80T Encoder Combo Set
- Manufacturer
- iFlight
- Product Category
- STACK, CONTROLLER AND ESC
- Update Date
- 2024-05-20
Description
Easy to do gimbal tuning, no need to do much calibration work anymore.
Power saving, 5 times long working time than gimbal without encoder system.
Twin IMUs.
Faster response, motor torque increasing instantly, no bug for difficult rotating angle anymore.
Encoder chip A5048a
Model: GM8112
Motor Out Diameter: Ф89.5±0.05mm
Configuration: 36N/42P
Motor Height: 33.4±0.2mm (Included with Encoder housing)
Hollow Shaft(OD): Ф25-0.008/-0.012 mm
Hollow Shaft(ID): Ф22+0.05/+0.1 mm
Wire Length: 610±3mm
Cable AWG: #24
Motor Weight: 446±1g
Wire plug: 2.5mm dupont connector
No-load current: 0.3±0.1 A
No-load volts: 22V
No-load Rpm: 380~420 RPM
Load current: 2A
Load volts: 20V
Load torque(g): 6000-9000
Motor internal resistance: 4.2Ω±5%（Resistance varies with temperature）
High voltage test: DC500V 1mA @2sec
Rotor housing runout: ≤0.1mm
Steering (axle extension): clockwise
High-low temperature test:
High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Maximum power: ≤80W
Working current: 3-5S
Working temperature: -20~60℃;10~90%RH
Detailed Information
Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency.
What's encoder technology in brushless gimbal control system?
The 3 axis stabilization gimbal system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (a tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes.
Price & Procurement
Associated Product
-
-
-
-
-
-
Capacity: 300 mAh Nominal voltage: 3.8 V Maximum discharge current: 60C ... -
DarkStar20: So light, it makes feathers look overweight. Perfect for sneaking th ... -
With 20A Blheli_s ESCs and an integrated ELRS RX, this FC lifts your drone’s per ... -
