CRSF to 6x PWM converter - Matek

Product overview

Part Number: CRSF to 6x PWM converter

Manufacturer: Matek

Product Category: OTHER PARTS

Update Date: 2024-05-20

Detailed Information

Matek Konvertor can turn a receiver with CRSF protocol into a receiver with 6 PWM outputs for servos. This will be especially appreciated by pilots of classic aircraft models without a FC. So they can use their favorite ELRS or Crossfire Nano receiver. The receiver is connected to the board via UART - pins TX1 and RX1. In addition to converting the CRSF signal to PWM, the board can also send telemetry data. On the board there is a VBat pin for the battery voltage sensor, a Curr pin for connecting an external current sensor, and RX2 and TX2 pins for connecting the GPS module.

The converter is fully adjustable. Settings are possible via UART2 using Matek Configurator. It is possible to set failsafe, trims, PWM output frequency or calibrate the current/voltage sensor.

The VBat pin is only for monitoring the battery voltage, not for powering the board. The board must be powered by 5V - perhaps from the BEC on the regulator.

Detailed informations

Wiring diagram

Price & Procurement

Associated Product

canopic jar 3d printing

Material: TPU Weight: up to 1g. Suitable for cameras: Caddx Ant lite, C ...
dipole antenna 5.8g ipex 7cm

Dipole antenna 5.8G ipex 7cm
dipole antenna 5.8g ipex 5cm

Dipole antenna 5.8G ipex 5cm
connector a30 male/female

A30 Male/Female Connector
canopy crux3

Weight: 1.2 g. Canopy for installing cameras: 14*14mm
battery GNB 300mah 1s 60c hv

Capacity: 300 mAh Nominal voltage: 3.8 V Maximum discharge current: 60C ...
GEPRC DarkStar20 O3 ELRS Cinewhoop Quadcopter

DarkStar20: So light, it makes feathers look overweight. Perfect for sneaking th ...
CrazyF411 ELRS AIO Toothpick Flight Controller (20A)

With 20A Blheli_s ESCs and an integrated ELRS RX, this FC lifts your drone’s per ...
Tiny1-C

256×192/160×120 Micro Thermal Camera. Tiny1-C is a long-wave (8~14μm) thermal ca ...