This is a super tiny yet cable 16x16mm F4 flight stack.  The flight controller includes the MPU6000 IMU, built in betaflight OSD, and a buck boost regulator.  The ESC supports a continous current of 5A with bursts to 7A, and runs BLheli_S firmware.  So in short if you are looking for a powerful yet tiny flight stack for your micro quadcopter, the TeenyF4 Pro is what you need.

Key Features

• Support programmable LED_strip
• Support BLheli/BLHELI_S suite Pass-through ready
• Support PPM, Oneshot125,Oneshot42,Multishot, Dshot150, Dshot300, Dshot600
• Default Dshot600
• Built-in voltage detection, alarm
• Built-in Betaflight-OSD
• Buzzer solder pin
• LED_STRIP connector

Specification

Flight Controller:

• Item name: TeenyF4 Pro flight controller board
• Model: TeenyF4 Pro
• Processor: STM32F405RGT6
• Sensor: MPU-6000 ( connected by SPI)
• Firmware Version: betaflight_3.2.0_OMNIBUSF4SD
  • Built-in betaflgiht OSD
  • Built-in Buck-Boost Converter
• Input Voltage: 1-2S Lipo
• Receiver: PPM, IBUS, SBUS, DSM2, DSMX etc.
• Size: 20*20mm
• Mounting hole: 16*16mm
• Mount Hole Diameter: 2mm ( M2 )
• Weight: 2.2g
• Application: for Micro FPV brushless drone

5A 4 in 1 ESC: ( Bottom )

• Item Name: Teenypro 4 In 1 5A BLHeli_S ESC
• Mode: Teenypro
• Input Voltage: 1-2S Lipo
• Con. Current: 5A
• Peak Current: 7A (5 Seconds)
• Firmware: BLHELI_S
• Processor: SILABS EFM8BB21F16G
• BEC: NO
• Size: 23x27mm (includes solder pad)
• Mounting Holes: 16x16mm (M2)
• Weight: 2.1g
• Firmware Target: BLHeli_S S_H_50_REV16_7
  • Support Dshot150 Dshot300 Dshot600 Oneshot125 Multishot PWM

Setting up your RX

• SBUS/IBUS/DSMX receiver please configure RX1 (UART1) as input, and enable Serial_RX
• PPM receiver don’t need to enable Serial_RX
• DSM/DSM2/DSMX receiver power from 3.3V
• SBUS and PPM receiver power from 5V

Included:

• 1x F4 Flight Controller Board
• 1x 5A 4 In 1 ESC
• 1x 6P Cable
• 8x M2*5+5 Nylon column
• 8x M2 Nuts
• 8x M2 Screw