The Mini Kakute F7 V3 Combo by Holybro comes with the Kakute F7 Mini V3, and the Tekko32 F4 45A 4-in-1 Mini ESC. Holybro is saving you time and guesswork by making this powerful stack that will give you max performance!

Specifications

Kakute F7 mini V3

• MCU: STM32F722RET6 32-bit processor,216MHz, 256Kbytes RAM, 512Kbytes Flash
• IMU: MPU6000 (SPI)
• Barometer: BMP280
• USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
• 5hardware UARTS (UART1,2,3,4,6)
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
• Onboard 16Mbytes for Blackbox logging
• 5V Power Out: 1.0A max
• 3.3V Power Out: 0.2A max
• Dimensions: 30x30mm
• Mounting Holes: Standard 20mm square to the center of holes
• Weight: 4g

Tekko32 F4 4in1 mini ESC (45A)

• F4 MCU with BLHELI32 firmware
• Maximum PWM output upto 96K (default 48K)
• Amperage meter scale ratio has been adjusted to 168.
• PWM input, TLM supported
• Voltage output (VBAT)
• NO output BEC
• Supports oneshot / Multishot / Dshot PWM
• Supports damped light
• Supports 3-6S lipo input
• Ext. cap needed for 6s (1000uf 35v for 6s usage.)
• Mounting holes: 20x20mm(M3)
• Size:30 x 39 mm
• Weight: 7.2g

PIN MAP

Included

• Kakute F7 mini V3 STACK *1
• Electrolytic capacitor: 1000uF 35v *1
• 8pin to 8pin 1mm pitch 65mm cable *1
• 8pin to 8pin 1mm pitch 25mm cable *1
• JST SH 6pin 150mm cable*1 ( The cable that goes to the CADDX Vista Air Unit is included.)
• JST GHR 8pin to JST GHR 6pin 80mm cable*1 ( The cable that goes to the DJI Air Unit is included.)
• JST GHR 8pin to JST GHR 6pin 150mm cable*1 ( The cable that goes to the DJI Air Unit is included.)

Resources

• HolyBro Kakute F7 Mini V3 Manual
• Holybro_Tekko32_F3_4in1_mini_ESC(45A)_manual