The SparkFun Qwiic pHAT Extension for the Raspberry Pi 400 provides you with a quick and easy solution to access all of the 400’s GPIO, stack your favorite HAT right-side up, or connect a Qwiic-enabled device to the I²C bus (GND, 3.3V, SDA, and SCL). Since the Qwiic system allows for daisy-chaining boards with different addresses, you can also stack as many sensors as you’d like to the mounting holes on the pHAT to create a tower of sensing power!

The Qwiic pHAT Extension connects to the Raspberry Pi 400’s GPIO using a 2×20 right angle header and extends out to the edge of the PCB. Two Qwiic connectors are included on each side of the board for easy access to the I²C bus. A set of large silicone bumpers have also been included for better stability when connecting the Qwiic pHAT Extension to the Raspberry Pi 400’s GPIO port.

Note: The Raspberry Pi 400 is NOT included. Check the Hookup Accessories section below for Raspberry Pi 400 options.

Features

• 2x Qwiic Connection Ports
• 10x Mounting Holes
• Reroutes and extends a Raspberry Pi 400’s 40-pin headers to a vertical position

Documents

• Schematic
• Eagle Files
• Board Dimensions
• Hookup Guide
• Qwiic Info Page
• GitHub Hardware Repo
• Raspberry Pi Resource Page