Product overview

Part Number: PPM Encoder Type 2

Manufacturer: Unmanned Tech

Product Category: OTHER PARTS

Update Date: 2024-05-20

Detailed Information

This PPM encoder will encode regular PWM inputs into a single PPM output. This allows you to combine up to 8 channels from a regular RC receiver to a single PPM input for your flight controller (like Pixhawk) or electronics project.

The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized. The open source firmware by John Arne and Olivier Adler as part of the ardupilot project..

The design of the PPM Encoder is based on the Paparazzi PPM Encoder.

Important Note: The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.

The jumper on the board no soldering default. In this case the board powered by FC

PPM Encoder Specification

Dimension(mm): 28 x 19 x 5
Weight(g): 9(include all wire)

How to power your receiver via PPM encoder?

There is a solder jumper that allows you to choose if you want your PPM encoder to route the power from your autopilot to your receiver. To do this you just need to solder a blog across SJ1 on the top of your PPM encoder board. For more information about this please visit the guide on how to power your PPM encoder

Kit Contents

PPM Encoder x 1
10 Pin input cable 60mm x1
4 Pin output cable 100mm x1

Price & Procurement

Associated Product

canopic jar 3d printing

Material: TPU Weight: up to 1g. Suitable for cameras: Caddx Ant lite, C ...
dipole antenna 5.8g ipex 7cm

Dipole antenna 5.8G ipex 7cm
dipole antenna 5.8g ipex 5cm

Dipole antenna 5.8G ipex 5cm
connector a30 male/female

A30 Male/Female Connector
canopy crux3

Weight: 1.2 g. Canopy for installing cameras: 14*14mm
battery GNB 300mah 1s 60c hv

Capacity: 300 mAh Nominal voltage: 3.8 V Maximum discharge current: 60C ...
GEPRC DarkStar20 O3 ELRS Cinewhoop Quadcopter

DarkStar20: So light, it makes feathers look overweight. Perfect for sneaking th ...
CrazyF411 ELRS AIO Toothpick Flight Controller (20A)

With 20A Blheli_s ESCs and an integrated ELRS RX, this FC lifts your drone’s per ...
Tiny1-C

256×192/160×120 Micro Thermal Camera. Tiny1-C is a long-wave (8~14μm) thermal ca ...